● Astern visual function
Through the WIFI connection of the camera, the smart device can realize the HD astern view.
● Reverse trigger recording
Every time you turn on the mobile phone to reverse, the reversing video is saved on the smartphone terminal, and five cycles are covered to record the driving track of each time you reverse, so as to ensure your safety responsibility.
● Intelligent electronic rearview mirror function
When entering the rearview video, you can watch the real-time rear view of the vehicle. It is viewed from a full perspective, which is smaller than the traditional rearview mirror.
Blurred vision improves driving safety.
● Intelligent background startup, voice call startup
Android system background detected the astern trigger signal, automatic start, no need to enter manually.Apple system voice call start, static IP link, Internet access and reverse at the same time.
Parameter:
1/4 CMOS
Total pixels: 720 * 504 pixels
Voltage: DC12V
Lens Angle: 170 degrees
IR night vision lights: 8 IR infrared night vision lights
Minimum illumination: 0 Lux
Waterproof rating: IP67
Suitable system: Android, IOS
Size: 340*172*60mm (color box)
Weight: 0.65KG
Use Tips:
● Interface icon; Rearview video view WIFI link set rearview mirror function
● Android device usage; When installing the software, click (background operation + startup) the background of the software will not consume power, the software will run in the background, and the reversing video will pop up automatically under any interface.In the car
Turn off the WIFI when you need to surf the Internet.
● Apple device usage; After the software is installed, set static IP 1; Connect to W-CAR name WIFI, 2 enter WIFI setting interface, remember "DHCP" (IP address). Subnet mask) the number of these two lines
Type, click "Static" here, fill in these two lines of Numbers below the static button (IP address).Subnet mask).3 click Back to set success.Set the static IP, can achieve WIFI and
3G and 4G simultaneous communication does not affect mobile Internet access.
● Voice call device starts; Apple USES Siri to call: "W-car" to launch the APP.
Product Installation:
1. First, turn off the on-board power supply. It is strictly prohibited to power the camera if the power cord is not properly connected.
2. Determine the installation location of on-board cameras.
Step 1. Remove the plastic shell from the back of the box and install it by locating the three power lines.
● The positive pole of the backlight (yellow power cord), please connect the positive pole of the backlight power cord.
●ACC power positive pole (red power cord), please connect to ACC wiring position on board.
● Negative grounding (black power cord), please connect to the negative wire harness.
The second step. Install the camera and remove the license plate lamp. The camera is connected to the main engine through the gap of license plate lamp. Connect the three power lines to the exact position, start the vehicle, adjust the better astern Angle, with screw
Fix the camera with the wire, and then fix it with the tie tape.